Peloton Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
This is the part if you are missing the jack.
I will try to post pics after I've replaced mine. Bad design to use the solder pads to hold the jack down. I will be using epoxy to hold it down. The required pads are the ones closet to the surface mount resistors and one or both grounds which are the pads closet to the edge of the board. If you tore the PCB traces away like the picture, you can probably solder bridge to the resistor.

Wish me luck.
Hi! I'm having the same issue and am going to attempt to solder it this week. Did you have any luck?
 
1 - 1 of 1 Posts
Top